Pocket Watch Main Spring Replacement

Welcome to the forum!
All visitors are welcome to view topics and posts.
MEMBERSHIP AND POSTING IS RESERVED FOR TASCIONE COURSE MEMBERS ONLY... http://www.tascione.com

Moderators: willofiam, Bob Tascione

Pocket Watch Main Spring Replacement

Postby BYJWR1 » Fri Dec 02, 2011 10:25 am

Hello Bob and Fellow Members,

I am working on an Elgin size 12 Pocket Watch that requires a new main spring. The main spring for
this watch has a tee setup on the barrel end. My problem is trying to insert the cross tee in the slot
of the barrel. I have a spring winder that I use to wind the spring and then insert the spring into the
barrel. Trying to insert the cross tee of the main spring into the barrel slot when inserting the main
spring into the barrel is a hit or miss situation. Perhaps I am not using the correct method?

I would appreciate your input on the above problem!

Thanks

BYJWR1
BYJWR1
 
Posts: 34
Joined: Sat Apr 02, 2011 8:22 am

Re: Pocket Watch Main Spring Replacement

Postby Bob Tascione » Wed Dec 07, 2011 1:50 pm

Hi BYJWR1,
Allowing the T end of the mainspring to project slightly outside of the slot of the mainspring winder and choosing a winder slightly smaller then the barrel ID to give a little wiggle room should allow you to insert the end into the slot or hole of the barrel before releasing the spring.
Hope this helps BYJWR1,
Bob
User avatar
Bob Tascione
 
Posts: 1545
Joined: Fri Apr 30, 2010 1:55 pm

Re: Pocket Watch Main Spring Replacement

Postby BYJWR1 » Sat Dec 10, 2011 9:12 pm

Thanks Bob!

BYJWR1
BYJWR1
 
Posts: 34
Joined: Sat Apr 02, 2011 8:22 am


Return to General Discussion Forum

Who is online

Users browsing this forum: Google [Bot] and 37 guests

cron