Page 1 of 1

Clock bushings

PostPosted: Thu May 31, 2018 2:52 pm
by Hank7421
A little help from you Clock makers out there. Before I begin taking apart my Sessions Movement, I would like to have a small set of appropriate bushings in case I run into an enlarged pivot hole. Could anyone suggest a particular size range bushing set that I would most likely need? I would appreciate any input on this subject....Hank

Re: Clock bushings

PostPosted: Fri Jun 01, 2018 5:28 am
by willofiam
Hank, that can be a difficult question... I understand why you ask though....bushings are expensive.....if your working on clocks there can be a large range of sizes...I am just guessing without having your clock in hand so my best advice is to go ahead and take it apart, measure the pivot sizes, plate thickness and order what you need or a set with those sizes included...if you want a quick answer and are intending on buying sets of bushing for the future for the average American time and strike clock movements I would be in the mid range....from pivot size 1.00mm to 1.75mm plate thickness possibly from 1.50mm to 2.00 mm....and these may not be all that would be needed, you have the center wheel arbor, great wheel arbors and different styles and configurations of movements to consider.

Re: Clock bushings

PostPosted: Fri Jun 15, 2018 8:34 am
by Hank7421
Thanks William, I'm going to take your advise and wait until I take the movement apart. I may not even need any bushings.