Hi guys, dont add more washers to tighten up on the minute hand, just recup your washer to fit, or if adding a new one make to fit just right..... I drilled out a cup in a block of maple with a 1/2" bull nose router bit,
- DSCN2598_01.JPG (37.38 KiB) Viewed 4019 times
I suppose you could use whatever and a assortment of sizes might come in handy.
I use a small ball end of a hammer or a rounded punch depending on what I have to accomplish.
- DSCN2599_01.JPG (34.27 KiB) Viewed 4019 times
- DSCN2600_01.JPG (33.36 KiB) Viewed 4019 times
Lightly tapping and making sure it comes out uniform, prefit, buff out, re-blue (as Bob taught us so well in his video) size a tapper pin and blue, and WHALLAH a one washer snug fit good looking minute hand washer
- DSCN2601_01.JPG (25.02 KiB) Viewed 4019 times