I needed to replace the (hour strike shaft on a 1933 vintage movement). However, the shaft was redesigned from the original 1933 version that had a bent wire instead of the crescent shaped piece that rides on the pin wheel and the bridge assy., adjuster that allows adjustment without separating the plates.
Does anyone have one of these around that they can measure and give me the precise location to drill the mounting holes in the rear plate
I can reassemble the movement and eyeball the location but I would rather not. . .
I was given some pictures but before I drill, I would like to be a little more confident. Using that information I have laid out the perspective location of the (threaded screw hole) and per the picture I have it marked at 4-1/10" from bottom of plate and 1/2" from the shaft. (rule is 1/2" wide)
Henry Smith
Lebanon PA