Hello fellow fourm'ers,
Bill here again. Couple of questions. As a jeweler I have used the ultrasonic for many years but apparently there are different cleaning solutions for watches. Could use some suggestions on which may be a good one. Now I keep reading about the rinse cycle, with jewelry I use a steam machine to get any residue or dirt that was left behind. This does not seem very smart for watch parts. So, could some one explain the rinse cycle, I know what it is but how is it preformed. Do you empty your solution and replace it with fresh water or use another liquid in a different container, etc.? Now for last. I do not have one to fix but have run across several in my years, that is watches that have been wound to tight and won't run and let the main spring unwind. Is there a normal cause for this problem?