Thanks Brian. Just found this photo
loose my head if it wasnt attached..
- DSCN9011.JPG (204.69 KiB) Viewed 32833 times
Being rather excited to see some finished product I spent some time polishing the pillars and feet. Since then I have decided to hold off on the final polishing of parts until the very end, focusing on fit and function for now. Here is how I set up for polishing the feet and pillars. Since they have a 8-32 threaded hole for mounting and I didnt want to hold anything that could possibly get damaged I made a short spigot with a threaded hole.
- DSCN9034.JPG (216.78 KiB) Viewed 32833 times
Using the smaller lathe (Schaublin 70) finding it easier to maneuver around and my microscope swings over it for close up inspection, now that can be a issue....not sure of the magnification I get from my microscope..all I know is it came out of a operating room and gets me REAL close to what I am working on, the issue??? every tiny detail is largely enhanced and I really dont think it is possible to get a flawless surface....after hours of trying I found a perfect surface to be a exercise in futility
Anyway, using a threaded rod I was able to safely mount the pillars and feet in the lathe for the polishing stage.
- DSCN9035.JPG (221.81 KiB) Viewed 32833 times
- DSCN9036.JPG (223.23 KiB) Viewed 32833 times
Using progressively finer grits of sandpaper, wood sticks, polish, rags, and everything else in the shop .....I had to end the madness before I lost ALL my hair
and be satisfied...